|
download There are two basic methods of obtaining the voltage. First method is to peel back the rubber boot and probe the wires with fine pins or wire. A piece of straightened, fine-gauge safety wire (common at hardware stores) inserts nicely between the wire and silicone water seal; just be sure to get it fully-inserted - about 20mm. Sewing pins also have been suggested
|
|
|
download Removing Gearbox • Place the MC on auxiliary stand BMW tool # 90 88 6 00 1 550 • Remove the seat. • Remove the left & right air duct trim panels. • Remove the fuel tank. Removing the fuel tank: Caution: Fuel is highly flammable and also represents a health risk. Use rea- sonable safety precautions. • Use special tool 90 88 6 13 3 010 to clamp both fuel lines prior to detaching them. • Disconnect the vent and drain lines. • Disconnect the fuel pump connector. • Take off the fuel tank. 90 88 6 13 3 010 Page 3 3 Remove the mufflers • Loosen clamp bolts. • Disconnect 02 sensor wire con- nector. • Remove two clips. • Pull mufflers back and down
|
|
|
download Introduction There are three main sections to this manual as follows: Section I – by Carl Kulow This section consists of basic maintenance procedures that were done on an R1150GS, 2001. Once you remove the various plastic covers from an R, RT or RS, the procedures should essentially be identical to those given here. Section II – by Various Authors Generally, this section contains more detailed instructions than those found in Section I, especially Stephen Karlan’s very detailed write-ups. This section also contains procedures that are not part of the normal maintenance schedule
|
|
|
|
<< Start < Prev 1 2 3 4 5 6 7 8 Next > End >>
|
| Results 8 - 14 of 52 |